|
Post by grindingbassline on Nov 22, 2008 16:02:33 GMT -5
When Smithing (doesn't matter what is being built) double-tap when in landscape orientation causes tool selection to come up off-screen. When rotated, one can see a portion of the dialog frame rotate down through the corner of the screen, then disappearing off screen again. Will try to grab screenshot but timing will likely prove impossible.
-=dave
|
|
|
Post by grindingbassline on Nov 22, 2008 16:07:46 GMT -5
Nope, can't get a shot of it. Also, once rotated to portrait (when the dialog window frame slides passed the corner of the screen), it doesn't pass again through that section of the window if rotated back to landscape, or visa versa.
Double-tapping a block in portrait mode brings up the tool selection dialog correctly.
AF: 2.0 HW: MB384LL OS: 2.1 JB: Yes
-=dave
|
|
|
Post by grindingbassline on Nov 23, 2008 19:59:17 GMT -5
Screenshot: Note dimmed screen edges but dialog is off-screen entirely. Similar issue here during tool setup but don't recall the steps to get this to happen: -=dave
|
|
|
Post by vistring on Nov 24, 2008 21:41:46 GMT -5
this error happens all the time too me regardless of axis of the phone. 8 bucks for some buggy code. I had higher expectations after the first one.
|
|
|
Post by grindingbassline on Dec 3, 2008 23:57:44 GMT -5
This was fixed in the 2.0.1 update
-=dave
|
|